When placing the new buttons on, line up this notch just in between the scroll wheel and the post where it’s connected. Unscrew these 4 screws to separate the board from the buttons. Lift up the button housing from right to left as there are 2 plugs on the left side. Turn the unit over, and pry the button cover off with a flathead screwdriver. These two middle screws need to come out from the underside. If you do not have the tool a flathead screwdriver is a good replacement. _ Please disconnect your RollerMouse Red from any power source before proceeding with the following instructions.Ī simple twist in this notch here with the tool that came with the RollerMouse will remove the wrist pad. You’ll need to send us the unit for us to personally repair, and we’ll promptly send it back to you within a few days of receiving it. _ This can also be remedied if you contact at us to create a repair support case. If no click is heard the caps are not set correctly.Ĭontact us to receive extra button caps for the button that is sticking to proceed with the instructions. Slide the roller bar back on the tube, and put the side caps back on.Īfter pressing them down, make sure to push the caps outwards toward the ends. If desired wipe down the bar with rubbing alcohol, but avoid any other components. Use a can of compressed air on and around the area of the sensor lens to remove debris.
The sensor will be visible in the middle section of the tube with the circuit board located within it. A Teflon based lubricant is preferred, but a lubricant like WD40 can be used in very small amounts. If moving the rollerbar has resistance after it’s been cleaned, apply some lubricant on the inner rim at each end. Use a can of compressed air on the internal and external surfaces of the roller tube, and a Q-Tip with some rubbing alcohol on the inner rim at each end. Once the caps are off, you can slide the roller off the bar towards the right side. WARNING: Do not remove cable ribbon cable located on the left hand side. Keep note which is left and right as they are specific to each side. Afterwards, pull both caps up and remove them. Push them inwards and you’ll hear them click. Located on both ends of the bar are two black caps. Please disconnect your RollerMouse Red from any power source before proceeding with the following instructions.
0 kommentar(er)
